Standard settings (for buildings and irrigation)

Aqua-4D® 60 for max. 60 L/min or 3,6 m3/h (max 3 apartments), incl 1 command 60 + 1 tube 60
Aqua-4D® 120 for max. 120 L/min or 7,2 m3/h (max 7 apartments), incl 1 command 60 + 2 tubes 60
Aqua-4D® 180 for max. 180 L/min or 10,8 m3/h (max 15 apartments), incl 1 command 60 + 3 tubes 60
Aqua-4D® 240 for max. 240 L/min or 14,4 m3/h (max 25 apartments), incl 1 command 60 v.4 TU + 4 tubes 60
Aqua-4D® 360 H for max. 360 L/min or 21,6 m3/h (max 40 apartments), incl 1 command 360 H + 1 tube 360

Technical data Tube 360 II

Length: 80.4 cm
Length with raccords : 88.9 cm
Inside diameter : 2 pouces
Weight with raccords : 8.7 kg
Operational temperature : max. 60 [°C]
Flow rate max. : 360 l / min. (21.6 m3 / h) at 3 bar pressure
Pressure lost max. 20 bar, Druckverlust bei V max. = 0.07 bar
Material : PVC-C, TC-Quickpipe, Thermoconcept GmbH & Co.
Permissions : SVGW t

Installation of Tube 360 II

Caution:
The installation must be made by sanitary installators or other professional of the branch.

The assembly of the series of Aqua-4D® appliances is done in general after the water meter.
The assembly of the tube in control is made with the arrow in the direction of the water run-off.
The Tube 360 II can be assembled horizontally or vertically, in flow going up or going down.
No mechanical intervention must be made on Tube 360.

Caution:
To pay attention to the equalization of the different potentials. If necessary, to connect the control of an end to the other of the tube with a copper wire (EP 3mm2 CU green/yellow)

Not to install the tube in the vicinity immediate of apparatuses such electric control panels, transformer, or other electric installations of equivalent or higher power.
The Tube 360 II must be assembled after treatment UV as well as the pumps.
For large buildings, we propose to install: a bypass witch arrived principal as well as a second system in the hot water circulation with 2 valves before and after the tube.